Novatek DDS-1 Dustless Drill Shroud 1″ – DDS3000

Novatek DDS-1 Dustless Drill Shroud for 1″ Concrete Bits

The Novatek DDS-1 turns a standard rotary or hammer drill into a dust-controlled tool for small-diameter concrete and masonry work. The shroud sits at the bit, captures silica dust at the point of cut, and routes it through a dust port to a connected vacuum so debris never reaches the operator’s breathing zone. For contractors drilling anchor holes on occupied or inspected job sites, that means cutting visible airborne dust without changing the drill they already own.

What the DDS-1 Does on Small-Bit Drilling

The DDS-1 is built for 1″ class bits used in anchor setting, conduit, and fastener holes. It clamps to the drill with a universal mount, holds against the surface while you drill, and feeds the captured dust straight to a shop or HEPA vacuum. Pair it with a HEPA vacuum and the dust is contained from the first hole through the last.

• Captures concrete and masonry dust at the bit, before it spreads into the work area
• Universal mount fits most rotary and hammer drills, including Dewalt, Craftsman, Bosch, Makita, and Ryobi
• Sized for 1″ diameter bits used in anchor and fastener installation
• Dust port connects to a shop or HEPA vacuum for source dust collection
• Supports OSHA Table 1 silica dust control when run with a HEPA vacuum
• Converts a drill you already own into a dust-controlled tool in minutes

DDS-1 Applications and Environments

Use the DDS-1 for concrete and masonry drilling, anchor and fastener installation, and conduit holes where small-diameter bits do the work. It fits crews running silica dust control on occupied buildings, schools, hospitals, and inspected sites where airborne concrete dust is not acceptable.

Specifications

Documents

Manual